:TRIGger:SPI:CLOCk:SLOPe
Command Syntax
:TRIGger:SPI:CLOCk:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:SPI:CLOCk:SLOPe command specifies the rising edge
(POSitive) or falling edge (NEGative) of the SPI clock source that will
clock in the data.
Query Syntax
:TRIGger:SPI:CLOCk:SLOPe?
The :TRIGger:SPI:CLOCk:SLOPe? query returns the current SPI clock
source slope.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also
•
•
•
Agilent 6000 Series Oscilloscopes Programmer's Reference
(see
page
564)
"Introduction to :TRIGger Commands"
":TRIGger:SPI:CLOCk:TIMeout"
":TRIGger:SPI:SOURce:CLOCk"
Commands by Subsystem
on page 332
on page 418
on page 422
3
417