Trigger:mode - Agilent Technologies MSO6102A Programmer's Reference Manual

3
Commands by Subsystem

:TRIGger:MODE

Command Syntax
:TRIGger:MODE <mode>
<mode> ::= {EDGE | GLITch | PATTern | CAN | DURation | IIC | EBURst
The :TRIGger:MODE command selects the trigger mode (trigger type).
Query Syntax
:TRIGger:MODE?
The :TRIGger:MODE? query returns the current trigger mode. If the
:TIMebase:MODE is ROLL or XY, the query returns "NONE."
Return Format
<mode><NL>
<mode> ::= {NONE | EDGE | GLIT | PATT | CAN | DUR | IIC
See Also •
•
•
Example Code
Example program from the start:
page 614
338
(see page 564)
| LIN | SEQuence | SPI | TV | USB | FLEXray}
| EBUR | LIN | SEQ | SPI | TV | USB | FLEX}
"Introduction to :TRIGger Commands"
":TRIGger:SWEep" on page 342
":TIMebase:MODE" on page 322
' TRIGGER_MODE - Set the trigger mode to EDGE, GLITch, PATTern, CAN,
' DURation, IIC, EBURSt, LIN, SEQuence, SPI, TV, or USB.
' Set the trigger mode to EDGE.
myScope.WriteString ":TRIGGER:MODE EDGE"
on page 332
"VISA COM Example in Visual Basic"
Agilent 6000 Series Oscilloscopes Programmer's Reference
on