Trigger:sequence:find - Agilent Technologies MSO6102A Programmer's Reference Manual

:TRIGger:SEQuence:FIND

Command Syntax
:TRIGger:SEQuence:FIND <value>
<value> ::= {PATTern1,ENTered | PATTern1,EXITed | EDGE1
The :TRIGger:SEQuence:FIND command specifies the find stage of a
sequence trigger. This command accepts three program data parameters;
you can use NONE to fill out the parameter list (for
example,"EDGE1,NONE,NONE").
PATTern1 is specified with the":TRIGger:SEQuence:PATTern command.
EDGE1 is specified with the :TRIGger:SEQuence:EDGE command.
Query Syntax
:TRIGger:SEQuence:FIND?
The :TRIGger:SEQuence:FIND? query returns the find stage specification
for a sequence trigger. NONE is returned for unused parameters.
Return Format
<find_value><NL>
<find_value> ::= {PATT1,ENT,NONE | PATT1,EXIT,NONE | EDGE1,NONE,NONE
See Also
•
•
•
•
•
Agilent 6000 Series Oscilloscopes Programmer's Reference
(see page 564)
| PATTern1,AND,EDGE1}
| PATT1,AND,EDGE1}
"Introduction to :TRIGger Commands"
":TRIGger:SEQuence:PATTern"
":TRIGger:SEQuence:EDGE"
":TRIGger:SEQuence:TRIGger"
":TRIGger:SEQuence:RESet"
on page 332
on page 412
on page 410
on page 415
on page 413
Commands by Subsystem
3
411