What's New In Version 4.00 - Agilent Technologies MSO6102A Programmer's Reference Manual

1
What's New

What's New in Version 4.00

New features in version 4.00 of the 6000 Series oscilloscope software are:
• The ability to :AUToscale selected channels only and specify the
• The :BUS command subsystem for controlling up to two buses made up
• Additional :CALibrate commands for starting the user calibration
More detailed descriptions of the new and changed commands appear
below.
New Commands
Command
:AUToscale:AMODE (see
:AUToscale:CHANnels (see
:BUS<n>:BIT<m> (see
:BUS<n>:BITS (see
:BUS<n>:CLEar (see
:BUS<n>:DISPlay (see
:BUS<n>:LABel (see
:BUS<n>:MASK (see
:CALibrate:STARt (see
:CALibrate:STATus? (see
:CALibrate:TEMPerature? (see
20
acquisition type and mode that is set after an :AUToscale.
of digital channels.
procedure, displaying the status of the last user calibration, and
displaying the temperature change since the last user calibration.
page
page
page 152)
page 153)
page 155)
page 156)
page 157)
page 158)
page 162)
page
Description
107) Specifies whether to keep the current
acquisition type and mode after subsequent
autoscales.
108) Specifies whether to autoscale the currently
displayed channels or all channels.
Includes or excludes the selected bit in a bus
definition.
Includes or excludes a list of bits in a bus
definition.
Excludes all digital channels from a bus
definition
Displays or hides the bus on the oscilloscope
display.
Assigns a label string to a bus.
Includes or excludes bits in a bus definition
according to a mask.
Starts the user calibration procedure.
163) Displays the summary results of the last user
calibration procedure.
page 165) Displays the change in temperature since the
last user calibration procedure.
Agilent 6000 Series Oscilloscopes Programmer's Reference