:TRIGger:USB:TRIGger
Command Syntax
:TRIGger:USB:TRIGger <value>
<value> ::= {SOP | EOP | ENTersuspend | EXITsuspend | RESet}
The :TRIGger:USB:TRIGger command sets where the USB trigger will occur:
• SOP — Start of packet.
• EOP — End of packet.
• ENTersuspend — Enter suspend state.
• EXITsuspend — Exit suspend state.
• RESet — Reset complete.
Query Syntax
:TRIGger:USB:TRIGger?
The :TRIGger:USB:TRIGger? query returns the current USB trigger value.
Return Format
<value><NL>
<value> ::= {SOP | EOP | ENTersuspend | EXITsuspend | RESet}
See Also
•
•
•
Agilent 6000 Series Oscilloscopes Programmer's Reference
(see
page
564)
"Introduction to :TRIGger Commands"
":TRIGger:MODE"
on page 338
":TRIGger:USB:SPEed"
on page 332
on page 434
Commands by Subsystem
3
435