Cls (Clear Status) - Agilent Technologies MSO6102A Programmer's Reference Manual

*CLS (Clear Status)

Command Syntax
*CLS
The *CLS common command clears the status data structures, the
device- defined error queue, and the Request- for- OPC flag.
If the *CLS command immediately follows a program message terminator, the output queue
N O T E
and the MAV (message available) bit are cleared.
See Also
•
•
•
•
•
•
Agilent 6000 Series Oscilloscopes Programmer's Reference
(see page 564)
"Introduction to Common (*) Commands"
"*STB (Read Status Byte)"
"*ESE (Standard Event Status Enable)"
"*ESR (Standard Event Status Register)"
"*SRE (Service Request Enable)"
":SYSTem:ERRor" on page 315
on page 77
on page 95
on page 80
on page 82
on page 93
Commands by Subsystem
3
79