:TRIGger:FLEXray:TRIGger
Command Syntax
:TRIGger:FLEXray:TRIGger <condition>
<condition> ::= {FRAMe | TIME | ERRor}
The :TRIGger:FLEXray:TRIGger command sets the FLEXray trigger on
condition:
• FRAMe — triggers on specified frames (without errors).
• TIME — triggers on specified bus cycles, segments, and slots.
• ERRor — triggers on selected active error frames and unknown bus
This command is only valid when the FLEXray triggering and serial decode option (Option
N O T E
FRS) has been licensed.
Query Syntax
:TRIGger:FLEXray:TRIGger?
The :TRIGger:FLEXray:TRIGger? query returns the current FLEXray trigger
on condition.
Return Format
<condition><NL>
<condition> ::= {FRAM | TIME | ERR}
Errors
•
See Also
•
•
•
•
•
•
•
•
•
•
•
Agilent 6000 Series Oscilloscopes Programmer's Reference
(see
page
564)
conditions.
"- 241, Hardware missing"
"Introduction to :TRIGger Commands"
":TRIGger:MODE"
on page 338
":TRIGger:FLEXray:ERRor:TYPE"
":TRIGger:FLEXray:FRAMe:CCBase"
":TRIGger:FLEXray:FRAMe:CCRepetition"
":TRIGger:FLEXray:FRAMe:ID"
":TRIGger:FLEXray:FRAMe:TYPE"
":TRIGger:FLEXray:TIME:CBASe"
":TRIGger:FLEXray:TIME:CREPetition"
":TRIGger:FLEXray:TIME:SEGMent"
":TRIGger:FLEXray:TIME:SLOT"
on page 535
on page 332
on page 371
on page 373
on page 374
on page 375
on page 376
on page 377
on page 378
on page 379
on page 380
Commands by Subsystem
3
381