Acceptance Tests (Recommendations); Contents And Depth Of The Acceptance Test; Content Of The C Omplete Acceptance Test - Siemens Sinamics S120 Function Manual

A.3

Acceptance tests (recommendations)

A.3.1

Contents and depth of the acceptance test

A.3.1.1

Content of the c omplete acceptance test

A ) Doc umentation
Documentation of the machine and of safety functions
● Machine description (with overview)
● Specification of the controller (if this exists)
● Function table:
– Active monitoring functions depending on the operating mode and the protective door
– Other sensors with protective functions
– The table is part or is the result of the configuring work.
● SI functions for each drive
● Information about safety equipment
B ) Functional testing of safety functions
Detailed function test and evaluation of SI functions used. For some functions, trace
recordings of individual parameters can be used. The procedure is described in detail in
Section Acceptance tests (Page 420).
● Encoder parameterization test
– Required when using the Extended Functions with encoder
– Only required at an encoder replacement
● Test of the SI function "Safe Torque Off" (STO)
– Required when used in Basic and/or Extended Functions
● Test of the SI function "Safe Stop 1" (SS1)
– Required when used in Basic and/or Extended Functions
– If the Extended Functions are used, a trace recording of individual parameters can be
● Test of the SI function "Safe Brake Control" (SBC)
– Required when using Basic and/or Extended Functions
● Test of the SI function "Safe Brake Test" (SBT)
– If the Extended Functions are used, a trace recording of individual parameters can be
● Test of the SI function "Safe Stop 2" (SS2)
– For this purpose, a trace recording of individual parameters can be used.
Safety Integrated
Function Manual, (FHS), 07/2016, 6SL3097-4AR00-0BP6
used.
used.
A.3 Acceptance tests (recommendations)
Appendix
403