Siemens Sinamics S120 Function Manual page 342

Acceptance test
Requirements
The acceptance test requirements (configuration check) for electrical drive safety functions
emanate from DIN EN 61800-5-2, Section 7.1 Point f). The acceptance test "configuration
check" is cited in this standard.
● Description of the application including a picture
● Description of the safety-relevant components (including software versions) that are used
in the application
● List of the PDS(SR) [Power Drive System(Safety Related)] safety functions used
● Results of all tests of these safety functions, using the specified testing procedure
● List of all safety-relevant parameters and their values in the PDS(SR)
● Checksum, test date and confirmation by testing personnel
Acceptance test
The acceptance test comprises 2 parts:
● Checking whether the safety functions in the converter are correctly set:
– Does the speed control handle the configured application cases in the machine?
– Do the set interface, times and monitoring functions match the configuration of the
● Checking whether the safety-relevant functions in the plant or machine function correctly.
This part of the acceptance test goes beyond the converter acceptance test:
– Are all safety equipment such as protective door monitoring devices, light barriers or
– Does the higher-level control correctly respond to the safety-relevant feedback signals
– Do the converter settings match the configured safety-relevant function in the
Documentation
The documentation consists of the following parts:
● Description of the safety-relevant components and functions of the machine or plant.
● Report of the acceptance test results.
● Report of the settings of the safety functions.
● Countersigned documentation.
342
machine?
emergency-off switches connected and ready for operation?
of the converter?
machine?
Function Manual, (FHS), 07/2016, 6SL3097-4AR00-0BP6
Safety Integrated