Acceptance Tests For The Safety Functions; Recommended Acceptance Test; Acceptance Test Sto (Basic Functions) - Siemens SINAMICS G115D Operating Instructions Manual

Distributed drive for conveyor technology control

Hide thumbs Also See for SINAMICS G115D:

Table of Contents

A.2 Acceptance tests for the safety functions

Acceptance tests for the safety functions

The following descriptions for the acceptance test are recommendations that illustrate the

principle of acceptance. You may deviate from these recommendations if you check the

following once you have completed commissioning:

• Correct assignment of the interfaces of each converter with the safety function:

– Fail-safe inputs

– PROFIsafe address

• Correct setting of the STO safety function.

Perform the acceptance test with the maximum possible velocity and acceleration in order

to test the expected maximum braking distances and braking times.

Non-critical alarms

The following alarms are issued following each system ramp-up and are not critical for

Operating Instructions, 12/2020, FW V4.7 SP13, A5E48681219B-002

SINAMICS G115D distributed drive