Switches - Xilinx ZCU106 User Manual

On first use of the SCUI, select FMC > Set VADJ > Boot-up and click USE FMC EEPROM
Voltage. The SCUI buttons are grayed out during command execution and return to their
original appearance when ready to accept a new command.
See the System Controller GUI Tutorial (XTP433)
and Board Setup Tutorial (XTP435)
system controller utility.
The MSP430 uses ID resistor encoding to allow the system controller utility to recognize
which type of board is active. See
resistors R516 and R517.
Table 3-53: MSP430 Board ID Encoding
Zynq UltraScale Board
ZCU102
ZCU106
Reserved
Reserved

Switches

[Figure 2-1, callouts 27, 29, 31, and 46]
The ZCU106 board includes power, configuration, and reset switches:
• SW1 power on/off slide switch (callout 29)
• SW5 (PS_PROG_B), active-Low pushbutton (callout 31)
• SW3 (SRST_B), active-Low pushbutton (callout 27)
• SW4 (POR_B), active-Low pushbutton (callout 27)
• SW6 U1 MPSoC PS bank 503 4-pole mode DIP switch (callout 46)
ZCU106 Board User Guide
UG1244 (v1.0) March 28, 2018
Chapter 3: Board Component Descriptions
[Ref 12]
[Ref 13] for more information on installing and using the
Table 3-53 for the configuration of the ID encoding
R516 R517
DNP DNP
DNP 10K
10K DNP
10K 10K
www.xilinx.com
and the ZCU106 Software Install
Send Feedback
118