Xilinx ZCU106 User Manual page 117

The board setup instructions are summarized here:
1. Ensure that the Silicon Labs VCP USB-UART drivers are installed (see
2. Download the SCUI host PC application.
3. Connect the micro-USB to ZCU106 USB-UART connector (J83).
4. Power-cycle the ZCU106.
5. Observe that SYSCTLR LED0 (DS47) blinks and LED1 DS46 is illuminated.
6. Launch the SCUI.
The SCUI GUI is shown in
X-Ref Target - Figure 3-44
ZCU106 Board User Guide
UG1244 (v1.0) March 28, 2018
Figure 3-44.
Figure 3-44: System Controller User Interface
www.xilinx.com
Chapter 3: Board Component Descriptions
[Ref
Send Feedback
7]).
X19204-050117
117