ZCU106 Evaluation Kit Quick Start Guide The ZCU106 Evaluation Kit contains all the hardware, tools, and IP required to evaluate and develop your Zynq® UltraScale+™ MPSoC design. This quick start guide provides instructions to set up and configure the board, run the built-in self-test (BIST), install the Xilinx tools, and redeem the license voucher.
Page 2
Built-In Self-Test (BIST) Instructions ZCU106 Evaluation Kit Set Configuration Switches STEP 1: Set mode switch SW6 to QSPI32. Boot Mode Mode Pins [0:3] QSPI32 Note: For this DIP switch, in relation to the arrow, moving the switch toward the label ON is a 0. DIP switch labels 1 through 4 are equivalent to Mode pins 0 through 3.
Page 3
Self-Test Assignments for PL LEDs MSB→ LSB Clock BRAM PL-DDR4 PS-DDR4 Flash X-Ref Target - Figure 1-2 Photo can vary from product. Power Good LEDs SW4 (POR_B) DONE LED SW15 (PB Switches) PL DIP (SW13) J52 (12V Power) SW1 (Power-On) www.xilinx.com Send Feedback...