Switches - Xilinx KC705 User Manual

Chapter 1: KC705 Evaluation Board Features
Table 1-27: GPIO Connections to FPGA U1 (Cont'd)

Switches

[Figure
The KC705 board Evaluation Board includes a power and a configuration switch:
•
•
Power On/Off Slide Switch SW15
[Figure
The KC705 board power switch is SW15. Sliding the switch actuator from the Off to On
position applies 12V power from J49, a 6-pin mini-fit connector. Green LED DS22
illuminates when the KC705 board power is on. See
onboard power system.
52
FPGA Pin Schematic
(U1) Net Name
AC6 GPIO_SW_W
G12 GPIO_SW_C
AB7 CPU_RESET
4-Pole DIP Switch
Y29 GPIO_DIP_SW0
W29 GPIO_DIP_SW1
AA28 GPIO_DIP_SW2
Y28 GPIO_DIP_SW3
User Rotary Switch
Y25 ROTARY_INCB
AA26 ROTARY_PUSH
Y26 ROTARY_INCA
User SMA
Y23 USER_SMA_GPIO_P
Y24 USER_SMA_GPIO_N
1-2, callout 27 - 28]
Power On/Off Slide Switch SW15 (callout 27)
FPGA_PROG_B SW14, active-Low (callout 28)
1-2, callout 27]
Caution!
Do NOT plug a PC ATX power supply 6-pin connector into J49 on the KC705 board
The ATX 6-pin connector has a different pinout than J49. Connecting an ATX 6-pin connector into
J49 will damage the KC705 board and void the board warranty.
www.xilinx.com
GPIO Pin
SW6.1
SW5.1
SW7.1
SW11.4
SW11.3
SW11.2
SW11.1
SW8.6
SW8.5
SW8.1
J13.1
J14.1
Power Management for details on the
KC705 Evaluation Board
UG810 (v1.3) May 10, 2013