Table of Contents
Advertisement
Board Hardware
SPI Addressing
The SPI does not use an addressed based system like the IIC Bus Interface uses. Instead,
devices are selected by dedicated Slave Select signals, comparable to a Chip Select signal.
Each SPI Slave device needs its own Slave Select signal driven from the SPI master. This
increases the total pin count, but decreases overhead and complexity, which increases the
available bandwidth and decreases bus contention.
The ML310 employs a single SPI device which is a 25LC640, 64k bits EEPROM. For more
details on this device, please review the data sheet available on the ML310 CDROM.
Table 2-15
Table 2-24
Table 2-24: SMBus and IIC Controller Connections
spi_miso
spi_mosi
spi_sck
spi_ss[0]
Push Buttons, Switches, Front Panel Interface and Jumpers
Push Buttons
System ACE Reset, SW1
SW1 provides a way to manually reset the System ACE CF (U38) device. When SW1 is
actuated it drives the signal PB_SYSTEM_ACE_RESET low which causes the LTC1326
(U31) to generate a 100us active low pulse. The active low output of the LTC1326 drives the
reset input of the System ACE CF (U38) device via signal SYSTEMACE_RESET_N.
When the System ACE CF device is reset, it causes a re-configuration of the XC2VP30
FPGA. The ace file used to program the device is selected via dipswitch, SW3, settings.
Please review the System ACE CF data sheet for more details, as it is located on the ML310
CDROM and also available on http://www.xilinx.com
The front panel interface header (J23) can also drive the PB_SYSTEM_ACE_RESET signal.
For more details on J23, please review section
ML310 User Guide
UG068 (v1.01) August 25, 2004
shows the FPGA and the EEPROM connected by the SPI bus.
U37
Virtex-II Pro
FPGA
XC2VP30
Figure 2-15: SPI EEPROM Device Interface
shows the connections between the SMBus/IIC controller. and the XC2VP30.
UCF Signal Name
* Note: This signal connects to U20 therm_l on the LM87. See data sheet for additional details.
www.xilinx.com
1-800-255-7778
Get other manuals https://www.bkmanuals.com
SPI Bus
XC2VP30 Pin (U37)
AJ10
AK10
AF12
AF13
"Front Panel Interface Connector,
U19
SPI
EEPROM
25LC640
Schem Signal Name
SPI_DATA_OUT
SPI_DATA_IN
SPI_CLK
SPI_DATA_CS_N
J23".
R
53
Advertisement
Table of Contents
