Xilinx ZCU106 User Manual page 90

Table 3-36: Power and Status LEDs (Cont'd)
Ref. Des.
DS19 PS_DDR4_VPP_2V5
DS20 PL_DDR4_VPP_2V6
DS21 VCCOPS_PGOOD
DS22 UTIL_5V0_PGOOD
DS24 VCCPSDDRPLL_PGOOD
DS25 UTIL_3V3_PGOOD
DS26 VCCOPS3_PGOOD
DS27 ENET_LED_1
DS29 UTIL_1V8
DS30 PL_DDR4_VTERM_0V60_PGOOD
DS31 PS_DDR4_VTERM_0V60_PGOOD
DS32 DONE
DS33 PS_ERR_STATUS
DS34 DP_VCC3V3
DS35 PS_ERR_OUT
DS36 POR_RST_B
DS37-DS44 GPIO_LED_1, GPIO_LED_[0,2:7]
DS46 MSP430_LED1
DS47 MSP430_LED0
DS49 UTIL_1V13_PG
DS50 MIO23_LED
DS51 USB3 MIC2544 U121 FLG
Notes:
1. See the Zynq UltraScale+ MPSoC Technical Reference Manual (UG1085)
MPSoC configuration pins.
ZCU106 Board User Guide
UG1244 (v1.0) March 28, 2018
Net Name LED Color
(1)
(1)
www.xilinx.com
Chapter 3: Board Component Descriptions
Green PS_DDR4_VPP_2V5 2.5 VDC power on
Green PL_DDR4_VPP_2V5 2.5 VDC power on
Green VCCOPS 1.80 VDC power on
Green UTIL_5V0 5 VDC power on
Green VCCPSDDRPLL 1.81 VDC power on
Green UTIL_3V3 3.3 VDC power on
Green VCCOPS3 1.81 VDC power on
Green EHPY U98 1000BASE-T link is established
Green UTIL_1V8 1.8VDC power on
Green PL_DDR4_VTERM 0.6VDC power on
Green PS_DDR4_VTERM 0.6VDC power on
Green MPSoC U1 bit file download is complete.
PS error status indicates a secure lockdown state.
Green Alternatively, it can be used by the PMU firmware
to indicate system status.
Green Display port 3.3VDC power on
PS error out is asserted for accidental loss of
Red power, an error in the PMU that holds the CSU in
reset, or an exception in the PMU.
POR U22 asserts RST_B low when any of the
monitored voltages (IN_) falls below its
Red
respective threshold, any EN_ goes low, or MR is
asserted.
Green USER GPIO LEDs
Green MSP430 U41 GPIO LED
Green MSP430 U41 GPIO LED
Green UTIL_1V13 1.13VDC power on
Green MPSoC U1 Bank 500 GPIO LED
Green PS USB 3.0 ULPI VBUS power error
[Ref 2] for more information about Zynq UltraScale+
Description
Send Feedback
90