Description Of The Parameter - Baumuller b maXX BM3000 Operating Manual

4.8
Operating Modes

4.8.13.12Description of the Parameter

122.1
Status
Status of operation mode "Coupled operation" (synchronization, normal operation) 
15 ... 13 Reserved
31 ... 18 Reserved
682 Parameter manual b maXX BM3000
Document no.: 5.12001.07
of 820
Bit Function
0 Initialization (reducing the speed or searching the active curve segment
from the entire linked curve)
1 Synchronize on the curve
2 Additional movement is in process
3 Total set speed is 0, whereby the following is valid
v = (v
Set,total
mit v :
Set,total
v :
Set,polynomial
v
Set,add. movement
4 Curve data are available
5 Reserved
6 Maximum total set speed was exceeded and was limited to maximum
7 Reserved
8 Switchover to reloaded curve possible (0->1); switchover was made (1->0),
see also bit 8 in
9 Reserved
10 The curve is synchronous (set value reached), see also bit 10 in
Status word 1
11 Reserved
12 The curve sequence was changed, see also bit 12 in
word 1
16 Display of the master axis direction
0: positive
1: negative
17 1: Master axis position is extrapolated
* gear factor) + v
Set,polynomial
Total set speed
Set speed from the polynomial calculation
: Set speed of the additional movement
Z108.3–
Status word 1
Set,add.movement
Z108.3–
Z108.3–
Status
Baumüller Nürnberg GmbH