7
8
9
3.4.1
Communication via the service cable
The service interface transmits controller parameters from a PC/laptop to the controller
via the parameterizing software ProDrive.
h Connect free USB-port of the PC/laptop with the controller
NOTE
The service cable BM5-K-USB-XXX must be used for the service interface X1, only.
The driver connection was installed on the PC/laptop with ProDrive, already. The settings
of the connection (baudrate etc.) are made in ProDrive. Refer to the online-help of
ProDrive.
Make sure that all safety devices are connected on the supply and motor sides and
are ready for operation.
Make sure that the encoder for motor control (sine-cosine encoder) is connected to
the encoder evaluation module with the appropriate encoder cable.
Make sure that the PC/Laptop is connected to the controller.
Commissioning BM3xxx
Parameter manual b maXX BM3000
Document no.: 5.12001.07
3
51
of 820