Preparations - Baumuller b maXX BM3000 Operating Manual

2.4

Preparations

2.4 Preparations
Specimen installation of a decentralized drive BM25xx.
The prerequisite for the commissioning is that assembly and installation have been car-
ried out correctly.
1
NOTE
Pictures for the next work steps can be found in the Operating Manual for the
b maXX
2
3
4
Motor data 
These data can be found, e.g., on the identification plate for the motor that you are using
(Identification for the commissioning.
plate)
Name
Motor type, designation
Nominal voltage U
Nominal current I
Nominal speed n
The motor database is used in this example; the values in the table are provided only for
checking purposes.
18 Parameter manual b maXX BM3000
Document no.: 5.12001.07
of 820
Make sure that the assembly is carried out correctly and, in particular, that all safety
regulations have been observed (see Assembly in the Operating Manual for the
®
b maXX 2500 basic unit).
®
2500 basic unit.
Make sure that the installation is carried out correctly and, in particular, that all safety
regulations have been observed (see Installation in the Operating Manual for the
®
b maXX 2500 basic unit).
ProDrive must be installed on the PC/Laptop. 
During commissioning you can, among other things, enter motor and encoder data in
the operating software or correct incorrect values. So that you can perform the com-
missioning efficiently, it is advantageous to have all the data at hand for the commis-
sioning. Data for Baumüller motors are available in the form of a "Motor Database"
within the operating software.
Make sure that all the necessary data are at hand.
N
N
N
Value, e.g. Used for entering in the parameter list /parame-
ter
DSD Parameter list/Motor configuration
Z107.2–
Motor type
330 V Parameter list/Motor configuration
Z107.8–
Motor nominal voltage
4,0 A Parameter list/Motor configuration
Z107.9–
Motor nominal current
3000 rpm Parameter list/Motor configuration
Z107.7–
Motor nominal speed
Baumüller Nürnberg GmbH