Fast Load Enabling/Disabling - StorageTek L180 Installation Manual

Entering Configuration Data
5. If you want to set the library Port 0 address, you must set the HARD
ADDRESS option to ENABLED and enter a port address:
a. Select ADDRESS from the Fibre Port 0 Configuration menu. The Port
b. Use the
c. Press the
• If the library Fibre Channel Port 0 address is the only configuration value
you wish to set at this time, press the
• If you wish to set other configuration values before you reset the library,
continue with the configuration.

Fast Load Enabling/Disabling

Fast Load is an option that:
Enabled:
Disabled:
Note: Some client software does not support the Fast Load feature. Consult
To set this value:
1. At the Lib Config Menu, press the arrow button until the cursor underscores
FAST LOAD.
2. Press the
3. Use the
4. When the screen displays your desired setting, press the
save the changes. Press the
5-12
Address menu will appear.
and
UP DOWN
three-field address. Permissible addresses are 000 through 125.
button to save the address.
SELECT
The robot mounts a cartridge into a drive and then immediately
performs its next task, not waiting for the tape drive to complete
its loading cycle. (Enabled or On).
The robot mounts a cartridge into a drive and waits at the drive
until the tape is fully loaded before beginning its next task.
(Disabled or Off).
with the systems administrator before enabling this feature.
button. An editing screen appears.
SELECT
and arrows to select either ON or OFF.
UP DOWN
Eleventh Edition
StorageTek Proprietary
arrows to select a digit for each field in the
RESET
button.
button to abort.
MENU
button to
SELECT
95896