Port 0 Worldwide Id; Setting The Library Fibre Channel Port 0 Address - StorageTek L180 Installation Manual

Port 0 Worldwide ID

When a library has a Fibre Channel interface, then the Port 0 worldwide ID
identifies the library's Port 0 (that is, the lower MPU card) on the Fibre Channel
system. The ID is automatically displayed when you access the Fibre Channel
Interface Configuration Menu. It cannot be changed.

Setting the Library Fibre Channel Port 0 Address

If the control path is Fibre Channel, you must set the port address.
To set this value:
1. From the Main Configuration Menu press the
Config Menu will appear and the cursor will line up with
LIB FIBRE I/F CONFIG.
2. Press the
The cursor will line up with PORT 0 CONFIGURATION.
Note: This menu also displays the Library and Port 0 Worldwide IDs.
3. Press the
Note: Consult with your system administrator before selecting the library's
4. If you want the network software to set the library Port 0 address, you must
set the HARD ADDRESS option to DISABLED:
a. Press the arrow buttons until the cursor underscores AUTO ADDRESS.
b. Press the
c. Use the
d. Press the
Note: The default for the hard address option is DISABLED.
95896
button. The Lib Fibre I/F Config Menu will appear.
SELECT
LIB FIBRE I/F CONFIG MENU:
LIBRARY WORLDWIDE ID:
00.00.00.00.00.00.00.00
PORT 0 WORLDWIDE ID:
00.00.00.00.00.00.00.00
PORT 0 CONFIGURATION
These two IDs are set at the factory and cannot be changed.
Each ID is 64 bits and uses the IEEE registered format.
button. The Fibre Port 0 Configuration menu will appear.
SELECT
Port 0 addressing option.
SELECT button. The Port Hard Address Edit Menu will appear.
and
UP DOWN
button to save the selected option.
SELECT
Eleventh Edition
StorageTek Proprietary
Entering Configuration Data
SELECT
arrows to select DISABLED.
button. The Lib
5-11