Command Line Interface; Snmp Software Application; Figure D-5. Cli Help And Help Snmp Commands - StorageTek L180 Installation Manual

Command Line Interface

The command line interface (CLI) is another way to configure SNMP for the
library.
for the library:

Figure D-5. CLI Help and Help SNMP Commands

cli> help
help [command]
diag
download
fsc
network
snmp
time
password
cli> help snmp
snmp view
snmp community [string]
snmp [enable|disable]
snmp port [port number]
snmp grace [number]
snmp reset
snmp list
snmp add
snmp add [ipaddr|name]
snmp add [ipaddr|name] [host port number]
snmp delete [[ipaddr|name] [host port number]] | all
cli> _

SNMP Software Application

The third way to configure SNMP for the library is by using the software
application. Consult the documentation that came with the software application
for directions about how to configure StorageTek's L-Series Tape Libraries to
support SNMP with that application.
95896
Figure D-5 shows an example of the CLI commands to configure SNMP
help on a specific command
execute diagnostics
download new image to prom
manipulate fault symptom codes
manipulate network information
manipulate SNMP configuration
view/modify library date & time
reset/modify library admin password
display SNMP Agent settings
set Community String
enable of disable SNMP Agent
set Agent Listening Port Number
(Valid: 161, 1024-65535)
set Write Grace Period Number
( 1-5 minutes )
set SNMP Agent configuration parameters
to default values
display SNMP Trap Recipient List
add a member to the SNMP Trap Recipient List by
answering individual prompts for values.
add a member to the SNMP Trap Recipient List using
some default values
add a member to the SNMP Trap Recipient List
using some default values
delete all or a selected member of the SNMP
Trap Recipient List
Where valid [host port number] values: (162, 1024-65535)
Eleventh Edition
StorageTek Proprietary
Configuration
D-9