2: Installing The Library; Tools - StorageTek L180 Installation Manual

Installing the Library
This chapter contains the procedures for preparing the L180 Tape Library
location, unpacking and positioning the library, removing the shipping
hardware, changing operating options, and connecting a laptop computer.
Table 2-1 on page 2-2
1. Remove this page from the book, and make sure all steps are completed in
the sequence listed.
2. When you complete a procedure, check off the item in the table.
3.
Important!
Read and observe the information in
Safety" on page xxvii

Tools

The following tools are necessary to install the library and tape drives:
• 3/4-inch wrench (STK tool crib PN WR08) or adjustable wrench* (STK tool
crib PN WR11)
• Phillips screwdriver*
• Torx set*
• 3/16-inch nut driver*
• 5/16-inch nut driver*
• Diagonal cutters or knife*
• Laptop personal computer
-
-
• Key to the library's front door (PN 310293301) from the library's shipping kit
* These tools are part of the tool kit (StorageTek PN 4019). Nut drivers can be
built with the included socket set.
Note: StorageTek also recommends that you use an ESD grounding kit
95896
summarizes the steps required to install the library.
before beginning the installation.
RJ-45 cable (PN 4108289xx) from the L180 library's shipping kit
RJ-45–DB9 adapter (PN 10410823) from the library's shipping kit
(StorageTek PN 4711) when working with electrical components inside
the library.
Eleventh Edition
StorageTek Proprietary
"Safety" on page xxiii
2
and "Fiber-optic
2-1