Starting Snmp; Table D-1. Snmp Default Settings - StorageTek L180 Installation Manual

Configuration
• SNMP software application
You can also use any SNMP application to change some of the agent's
settings.
You must be MIB-aware and refer to the Lseries.mib for specific
information.
The library comes configured with some default settings shown in

Table D-1. SNMP Default Settings

Setting
Port number
Community String
Grace Period
Trap Recipient
List
SNMP (agent)

Starting SNMP

To start SNMP for the library, you need to:
1. Configure the library:
a. Enable the agent.
b. Add recipients to the trap list (if needed).
c. Make any optional changes to the default settings.
2. Re-IPL the library.
Note: You must re-IPL the library for the changes to take effect.
D-6
Default Description
Valid port numbers are 161, and
161
1024 to 65535.
Agent community string. When
public
set to public, requests coming
from any community string will
be accepted.
1 to 5 minutes
5 minutes
Once you enter the password,
you have 1-5 minutes to
values for the agent.
This list contains up to 12
Empty
recipients with no duplicate
entries.
Enabled or disabled.
Disabled
Eleventh Edition
StorageTek Proprietary
Table D-1:
any
Set
95896