Figure 3-4. Dlt Drive Cable Connections - StorageTek L180 Installation Manual

.
Figure 3-4. DLT Drive Cable Connections (C67056)
1
1. DLT Drive
2. SCSI connection at the drive (single end of drive Y-cable)
3. SCSI connection at the drive bulkhead (dual end of drive Y-cable)
4. Exterior of drive bulkhead
5. Jackscrew
CAUTION:
Connector damage: Check the library drive connector and make sure it
is not stuck in a locked position from the vibration during shipping. This
connector provides power and library interface to the drive.
12. Firmly grasp the drive at the rear with one hand and place the other hand
under the drive tray.
13. Carefully guide the drive into its slot. Push it in as far as it will go and firmly
seat the drive.
14. Turn the thumbscrew clockwise until it is secure, do not overtighten the
thumbscrew
15. Connect the single end of the Y-cable to the SCSI connector on the rear of
the drive.
16. Place the drive's power switch to the ON (|) position.
17. Install any other drives.
95896
3
2
Eleventh Edition
StorageTek Proprietary
Installing DLT Drives
5
4
C67056
3-7