Library Worldwide Id; Enabling Or Disabling Fast Load - StorageTek L700 Service Manual

Operator Panel Entry

Library Worldwide ID

When a library has a Fibre Channel interface, the library's worldwide ID identifies the
library as a node on the Fibre Channel system. The ID is automatically displayed when
you access the Fibre Channel Interface Configuration Menu. It cannot be changed.

Enabling or Disabling Fast Load

These two terms are defined as follows:
Fast load on:
Fast load off:
Note: Some host software does not support the fast load enabled option. Check with
Enable or disable the Fast Load feature from the Lib Config Menu.
To set this feature:
1. At the Lib Config Menu screen, press the arrow button until the cursor underscores
FAST LOAD.
2. Press the
An editing screen appears.
3. Press the up and down arrow buttons to select either ON or OFF.
4. Press the
abort.)
5. If you have already changed the library's SCSI ID or Port 0 address and are planning
to exit the Main Configuration Menu at this time, you must press the
If you want to set other configuration values, continue with the next section.
If you have not changed the library's SCSI ID or Port 0 address and are not setting
other configuration values, press the
2-26
The robot will mount a tape to a drive and then immediately report the
move completed.
The robot will mount a tape to a drive and wait at the drive location
until the tape is completely loaded before reporting the move
completed.
the customer for their requirement.
button.
SELECT
button to save the changes. (You may press the
SELECT
Fourteenth Edition
StorageTek Proprietary
button until you exit all menus.
MENU
button to
MENU
button.
RESET
95846