Library Name; Ip Address - StorageTek L180 Installation Manual

Entering Configuration Data
Use the same procedure to complete the library's four network entries:
1. At the Main Configuration Menu, press the down arrow to line up the cursor
with NETWORK CONFIG.
2. At the Network Config Menu, press the
cursor up with each entry:
Entry

LIBRARY NAME

IP ADDRESS

NETWORK GATEWAY
SUBNET MASK
3. Press the
4. On the editing screen:
-
-
-
5. After you have set the four network configurations, continue with
Configuration"
Note: You only need to configure DNS if the SNMP agent is set to trap
Library Name
The library name is strictly a local convention. It is mapped to the IP address
and does not affect operation. The library name is assigned by the system
administrator.
IP Address
A four-byte Internet Protocol (IP) address must be set by the system
administrator. The value identifies the library and makes it accessible through a
network. An example of an IP address entry is
Note: The IP address must be set to use the L-Series Library Admin.
5-16
Description
The systems administrator might assign a library name
that is mapped to the IP address.
Do not enter a library name longer than 30 characters.
For the customer to be able to use the L-Series Library
Admin, you must set the IP address.
Entering this address is optional. It serves to indicate
the gateway connection between subnets.
The systems administrator might assign the library a
subnet mask address if one is required.
button. An editing screen appears.
SELECT
Use the UP and DOWN
Use the button to move right to the next field.
SELECT
Use the button to move left to the previous field.
MENU
to complete the network entries for the library.
named recipients; if SNMP is set for numbered recipients, no entries
are required.
Eleventh Edition
StorageTek Proprietary
and
UP DOWN
arrows to select a value for each field.
129.80.24.131
arrows to line the
"DNS
.
95896