Routing The Power Cable - StorageTek L180 Installation Manual

Tape library
Hide thumbs Also See for L180:
Table of Contents

Advertisement

Routing the Power Cable

To route the power cable, see
1. Make sure that the power source circuit breaker is turned off and that the
library power switches are in the down (OFF) position.
2. Loosen the two screws (Torx 15) that hold the strain relief in place.
3. Insert the female connector through the hole in the library floor. Make sure
the power cable is labeled with the circuit breaker number and location.
Note: If the installation requires this cable to be under the floor, carefully pull
4. Insert the power cable connector into the bottom of the AC power
distribution unit.
5. Tighten the screws on the strain relief.
Note: Safety agency standards require that your power receptacle is located
Remarque : Les normes des organismes de sécurité requièrent que votre prise de
H inweis: Gemäß den geltenden sicherheitsrechtlichen Vorschriften darf die
Wskazówka: Przepisy BHP wymagaj ą, aby skrzynka zasilania znajdowała się w
95896
the cable up through the hole in the floor.
within 2.8 m (9.2 ft) of the library. The power receptacle must also be
easily accessible.
In sites where the power cable is directly wired to a power source, the
facility must have a readily accessible disconnect device incorporated in
the fixed wiring.
courant soit située à moins de 2,8 m de la bibliothèque. La prise de courant
doit être d'accès aisé.
Sur les sites où le câble d'alimentation est directement connecté à une source
d'alimentation, un système de déconnexion facile d'accès doit être intégré au
câblage fixe.
Netzsteckdose maximal 2,8 m von der Library entfernt sein. Außerdem muß
die Steckdose gut zugänglich sein.
Wenn das Netzkabel fest an die Stromquelle angeschlossen ist, muß sich in der
Festverdrahtung eine gut zugängliche Unterbrechungseinrichtung befinden.
odleg ło ści 2,8 m od biblio te ki. Do skrzynki zasilania musi być łatwy dostęp .
W miejscach, gdzie kabel zasilania jest bezpo średnio pod łączony do źród ła
pr ądu, w układzie zasilania zamon towanym na stałe musi być wbudowane
urz ąd zenie pozwalające na łatwe od łączenie źród ła p rądu .
Eleventh Edition
StorageTek Proprietary
Figure 4-2 on page 4-4
Connecting Power
and:
4-5

Advertisement

Table of Contents
loading

Table of Contents