Table of Contents
Advertisement
If you want to set the library Port 0 address, you must set the HARD ADDRESS
option to ENABLED, enter a port address by:
a. Selecting ADDRESS from the Fibre Port 0 Configuration menu. The Port
b. Pressing the up and down arrow buttons to select a digit for each field
c. Pressing the
7. If the library Fibre Channel Port 0 address is the only configuration value
you wish to set at this time, press the
other configuration values before you reset the library, continue with the
next section.
Reviewing Port 0 Worldwide ID
When a library has a Fibre Channel interface, the Port 0 worldwide ID identifies
the library's Port 0 (that is, the lower MPU card) on the Fibre Channel system.
The ID is automatically displayed when you access the Fibre Channel Interface
Configuration Menu. It cannot be changed.
Reviewing Library Worldwide ID
When a library has a Fibre Channel interface, the library's worldwide ID
identifies the library as a node on the Fibre Channel system. The ID is
automatically displayed when you access the Fibre Channel Interface
Configuration Menu. It cannot be changed.
Enabling/Disabling Fast Load
These two terms are defined as follows:
Fast load on: The robot will mount a tape to a drive and then immediately
Fast load off: The robot will mount a tape to a drive and wait at the drive
Note: Some host software does not support the fast load enabled option.
Enable or disable the Fast Load feature from the Lib Config Menu. To set either
feature:
1. At the Lib Config Menu screen, press the arrow button until the cursor
underscores FAST LOAD.
2. Press the
An editing screen appears.
95845
Address menu will display.
in the three-field address. Permissible addresses are 001 through 125.
button to save the address.
SELECT
report the move completed.
location until the tape is completely loaded before reporting
the move completed.
SELECT
button.
Tenth Edition
Entering Configuration Data
button. If you wish to set
RESET
3-7
Advertisement
Table of Contents
