Preparing T9840 Drives
Mounting a Cartridge to an LTO Drive
To mount a cartridge to an LTO drive:
1. Locate a cartridge.
2. Insert the cartridge into the LTO drive using the direction shown in
Figure 6-5 on page
3. Wait for the indicator on the front panel of the drive to stop blinking.
Dismounting a Cartridge from an LTO Drive
To dismount a cartridge from an LTO drive:
4. Press the dismount button on the front panel of the drive.
Note: Do not hold down the button.
One of the following conditions can occur:
• After the tape rewinds, the cartridge ejects from the LTO drive.
• The cartridge fails to eject after the tape rewinds. Refer to the drive
5. Gently pull the cartridge out from the drive.
Preparing T9840 Drives
Instructions for preparing the T9840 Tape Drives appear in the T9840/T9940
Tape Drive Installation Manual.
6-10
6-9.
Remove the cartridge from the LTO drive.
manufacturer's documentation to correct this condition.
Eleventh Edition
StorageTek Proprietary
95896