Installation Instructions; Table C-1. Library Admin Functions - StorageTek L180 Installation Manual

Installation Instructions

Installation Instructions
Note: When the operator panel displays "Web Enabled," the Personality
To install the L-Series Library Admin:
1. Make sure the library is powered-on and initialized.
2. Make sure the library network configurations have been completed.
See
Referring to
3. Make sure the Ethernet (
4. Connect the Personality Module to the DB9 connector.
Note: The Library Admin software is disabled if the Personality Module is
5. Reset the library (cycle power or open and close the front door).
6. Start the L-Series Library Admin by accessing Netscape or Internet Explorer
and entering your library name or IP address at the Address Bar.
See Figure C-1 on page C-3
and L700 Tape Libraries.

Table C-1. Library Admin Functions

Select Tab...
Monitor
Maintenance
Statistics
Configuration
C-2
Module is installed and Library Admin is enabled.
"Drive Entries" on page 5-21
Figure 1-2 on page
Enet
not installed.
for an example of the Library Admin for the L180
For Information About...
• Cell map
• Drive status
• FSC log
• Tape inventory
• Diagnosing a problem
• Performing a code load
• Generating reports
• Rebooting the library
• Library
• Drives
• Cells
• Cleaning cartridge
• Library
• Drives
• Network
• Cleaning count threshold
Eleventh Edition
StorageTek Proprietary
for information.
1-3:
) cable is connected.
95896