Install Interface Cables at Host
Install Interface Cables at Host
Install the free end of the interface cable (Fibre Channel or SCSI) to the
applicable hub, switch, or host.
CAUTION:
For SCSI cables, remove power from the 9840 Tape Drive before
connecting to the host.
Note: If you are attaching to a 50-pin SCSI bus, an adapter is required (part
Manually Load Cartridges
Test each installed drive to ensure it loads and unloads a cartridge correctly.
Return System to Operator
After installation and testing of the 9840 Tape Drive. Follow these steps before
you turn the unit over to the customer:
1. Place the drive online (see
2. Return to the 9738 library installation documentation and complete the
library installation, if applicable.
Note: The 9738 library configuration must be updated to identify 9840
3. If applicable, provide the operator with training on the 9840 Tape Drive.
4. If applicable, provide training on placing a service call.
3-54
number 10148010).
Tape Drives.
Sixth Edition
Chapter 4, "Getting
Started").
95741