Cleaning Cartridge Warning Count; Figure 5-10. Cleaning Information Menu - StorageTek L180 Installation Manual

Cleaning Cartridge Warning Count

4. On the editing screen, use the
Note: To reset the screen characteristics to the default values, line up the
5. When the value is correct, press the
Press the
• If you have already configured the library, network, and tape drives, and
are planning to exit the Main Configuration Menu, press the
• If you have not changed the library's configuration, you may exit the
configuration menu to do other tasks.
CAUTION:
Lost data: You must press the RESET button for the configuration
changes to take effect. If you try to exit the Main Configuration Menu, a
message will appear requesting that you reset the library.
Cleaning Cartridge Warning Count
Figure 5-10
customer has enabled the Auto Clean feature, use the operator panel to set the
maximum number of times a cleaning cartridge can be used. This menu also
lets you check the number of times a cleaning cartridge has been used.

Figure 5-10. Cleaning Information Menu

CLEANING INFO
NUM CLEAN CARTRIDGES: 00
DLT WARN COUNT: 000
9840 WARN COUNT: 000
HP LTO WARN COUNT: 000
IBM LTO WARN COUNT: 000
SGT LTO WARN COUNT: 000
EXPORT CARTRIDGES
IMPORT CARTRIDGES
CLEAN CARTIDGE INFO
After a predetermined count, a cleaning cartridge must be replaced and
disposed of at the site. If Auto Clean is enabled, use the operator panel to set
the warning count of a cleaning cartridge.
The warning count should be set lower than the cartridge's recommended
usage (or maximum warning count displayed on the operator panel). This
5-26
cursor with RESTORE DEFAULTS and press the
button to abort.
MENU
shows an example of the cleaning information screen. If the
Eleventh Edition
StorageTek Proprietary
and arrows to change the value.
UP DOWN
button to save the changes.
SELECT
button.
SELECT
button.
RESET
95896