Fibre Channel Drive Entries (Lto Only) - StorageTek L180 Installation Manual

To configure SCSI tape drives:
1. Press an arrow button until the cursor underscores DRIVE CONFIG.
2. Press the
cursor will align with the first drive on the list.
3. Use the arrow buttons to scroll to the drive you wish to change and press
the
4. Use the
5. When the ID is correct, press
screen will appear to indicate that the library is saving the new ID. Then the
drive configuration menu will re-appear.
Note: The new SCSI ID for the tape drive might not appear right away.
6. Press the
(which is the drive's on bus status field).
7. Press the
8. Use the
9. When your choice is highlighted:
• Press the
• Press the
The drive configuration screen will reappear.
10. Continue these steps until all drives are configured.

Fibre Channel Drive Entries (LTO Only)

You may either set a hard Fibre Channel address of 0 for LTO drives or allow
the address to be set automatically, through arbitration.
Note: Before you enter an LTO Fibre Channel address to 0, you must first set
To set this value:
1. Press the arrow buttons to scroll to the drive you wish to configure and
press the
addressing to enabled or disabled.
2. Press the
3. Press
95896
button. The screen will list all installed drives, and the
SELECT
button. The Set Drive SCSI ID Menu will appear.
SELECT
and arrows to change the ID.
UP DOWN
arrow to get to the drive's second line of information
DOWN
button. The Set Drive SCSI Bus Menu will appear.
SELECT
and arrows to change the bus status to ON or OFF.
UP DOWN
button to save the changes.
SELECT
button to abort.
MENU
the drive's Fibre Channel hard address option to enabled.
If you configure the drive for soft addressing, you allow the network to
configure the address. To do this, you must set the Fibre Channel hard
address option to disabled. The default for this option is disabled.
SELECT button. The screen will allow you to select hard
and arrows to line up with your choice.
UP DOWN
and:
SELECT
Eleventh Edition
StorageTek Proprietary
Entering Configuration Data
to save your changes. A message
SELECT
5-23