To install a DLT drive:
1. Open the rear door of the library by gently pulling on the finger slot.
2. Open the library drive access door (inside the rear door).
3. Open the drive package.
4. Remove the packing material.
Note: Check with the customer for a maintenance agreement on the drives. If
5. Check the DLT drive for the terminating power jumper selection
(TERMPWR).
Figure 3-3. DLT Drive Terminating Power Jumper (C67054)
2
1. DLT drive
2. Load latch
3. TERMPWR jumper (enabled)
95896
the drives are to be returned for repair, have the customer retain one
shipping box (with packing material) in case a drive must be returned
to the factory. Some maintenance agreements allow drive replacement
by trained and certified personnel on the customer's staff.
Eleventh Edition
StorageTek Proprietary
1
3
Installing DLT Drives
C67054
3-5