Table 3-3. Hessen Status Flags And Default Bit Assignments - Teledyne T200 User Manual

Table 3-3. Hessen Status Flags and Default Bit Assignments

SAMPLE FLOW WARNING
OZONE FLOW WARNING
RCEL PRESS WARNING
BOX TEMP WARNING
RCELL TEMP WARNING
IZS TEMP WARNING
PMT TEMP WARN
CONV TEMP WARNING
INVALID CONC
In MANUAL Calibration Mode
In ZERO Calibration Mode
In SPAN Calibration Mode
In WARMUP Mode
UNITS OF MEASURE FLAGS
UGM
MGM
PPB
PPM
SPARE/UNUSED BITS
MANIFOLD TEMPERATURE
OZONE GEN OFF
SYSTEM RESET
RELAY BOARD WARNING
REAR BOARD NOT DETECTED
AUTOZERO WARNING
1
Only applicable if the optional internal span gas generator is installed.
2
Only applicable if the analyzer is equipped with an oxygenator option.
3
It is possible to assign more than one flag to the same Hessen status bit. This allows the grouping of
similar flags, such as all temperature warnings, under the same status bit.
Be careful not to assign conflicting flags to the same bit as each status bit will be triggered if any of the
assigned flags is active.
083730200A DCN7962
STATUS FLAG NAME
3
WARNING FLAGS
1
OPERATIONAL FLAGS
UNASSIGNED FLAGS (0000)
2
Teledyne API T200 NO/NO
DEFAULT BIT ASSIGNMENT
(USER EDITABLE; ALSO SEE NOTE
HVPS WARNING
FRONT PANEL WARN
ANALOG CAL WARNING
CANNOT DYN ZERO
CANNOT DYN SPAN
Instrument is in MP CAL mode
/NO Analyzer with NumaView™ Software
2 x
)
3
0001
0002
0004
0008
0010
0020
0040
0080
8000
0200
0400
0800
1000
0000
2000
4000
6000
0100
89