Table of Contents
Advertisement
Chapter 2: Plugging into a Target System
Plugging into the Motorola QUADS Target System
To connect the emulator to the Motorola QUADS
1 Turn OFF power.
If the emulator is currently plugged into a different target system, turn that target
system's power OFF. Then, turn emulator power OFF.
2 Plug the emulator probe into the Motorola Quads Board.
The emulator contains devices that are susceptible to damage by static discharge.
Take precautionary measures before handling the emulator probe to avoid damage.
The Motorola Quads board contains two 68360 processors: one running in Master
mode, and the other running in Slave mode. The emulator must be plugged into the
master processor.
Make sure pin 1 of the Quads board microprocessor socket and pin 1 of the
emulator probe are properly aligned before inserting the probe into the socket.
Otherwise, you may damage the emulator circuitry. Three or four pin protectors
will be required to lift the probe above other hardware on the Quads board.
Ensure that the default clock module is plugged in. The default clock module must
be installed in the emulator probe in order for the 68360 emulator to work with the
Quads board. Refer to the Hewlett-Packard MC68360 Emulator/Analyzer
Installation/Service/Terminal Interface User's Guide for details.
34
Advertisement
Table of Contents
