To Modify The Last Trace Command Entered - HP MC68360 User Manual

To modify the last trace command entered

• Choose Trace→Trace Spec and use the dialog box to select and edit a trace
command.
• Using the command line, enter:
trace modify_command
The Trace Specification Selection dialog box contains a list of trace specifications
executed during the emulation session as well as any predefined trace
specifications present at interface startup.
You can predefine trace specifications and set the maximum number of entries for
the dialog box by setting X resources (see Chapter 10, "Setting X Resources").
The trace modify_command command recalls the last trace command. The
advantage of this command over command recall is that you do not have to move
forward and backward over other commands to find the last trace command; also,
the last trace command is always available, no matter how many commands have
since been entered.
Chapter 7: Using the Emulation-Bus Analyzer
Making Simple Trace Measurements
181