Run - HP MC68360 User Manual

Chapter 11: Emulator/Analyzer Interface Commands

run

run
This command causes the emulator to execute a program.
If the processor is in a reset state, run will cause the reset to be released.
If the emulator is configured to run directly into user code out of reset, the monitor
will not be entered and part of your debug environment may be temporarily
disabled. A subsequent break into the monitor will restore it. See the "Enter
monitor from reset?" question in the configuration menu for more information.
If the from parameter and an address is specified, the processor will start running
your program at that address. Otherwise, the run will occur from the address
currently stored in the processor's program counter.
A run from reset command will reset the processor and then allow it to run. It is
equivalent to entering a reset command followed by a run command.
A run from soft_reset command will pulse the 68360 soft reset line to cause a soft
reset.
If the emulator is configured to participate in the READY signal on the CMB, then
this emulator will release the READY signal so that it will go TRUE if all other
HP 64700 emulators participating on that signal are also ready. See the
cmb_execute command description.
Qualifying a run command with an until parameter causes a software breakpoint to
be set before the program is run.
If you omit the address option (--EXPR--), the emulator begins program execution
at the current address specified by the emulation processor program counter. If an
367