To Define A Storage Qualifier - HP MC68360 User Manual

Examples To count occurrences of a particular bus state in the trace (this requires the 1K
analyzer speed to be set to "Slow" in configuration):
trace counting address 10h
Count all states in the trace:
trace counting anystate
Count time in the trace:
trace counting time
Disable counting in the trace:
trace counting off

To define a storage qualifier

• Enter the storage qualifier (such as status read) in the entry buffer. Then
chooseTrace→Only().
• Using the command line, store only certain states in the trace list by entering:
trace only <bus_state>
<bus_state> represents a combination of address, data and status expressions that
must be matched to satisfy the storage qualifier.
Storage qualifiers can help filter unwanted information from program execution
and improve your trace measurement. The analyzer stores only the information
specified in the storage qualifier. Note that if you have a sequencer or trigger
specification, any states given there are shown in the trace list even if they don't
meet the storage qualifier.
Chapter 7: Using the Emulation-Bus Analyzer
Making Complex Trace Measurements
217