HP MC68360 User Manual page 450

Chapter 12: Emulator Error Messages
Restricted to real time runs (Error 40)
Restricted to real time runs (Error 40)
Cause: While the emulator is restricted to real-time execution, you have attempted
to enter a command that requires a temporary break to the monitor for processing
(such as a request to display target system memory locations). The emulator will
not allow temporary breaks while the emulator is in the reset state or while the
target program is running.
Action: Break to the monitor using the break command, and then execute the
desired command or disable the real time mode.
Retry limit exceeded, transfer failed (Error 412)
Cause: The limit for repeated attempts to send a record during a transfer operation
was exceeded; therefore, the transfer was aborted.
Action: Retry the transfer. Make sure you are using the correct command options
for both the host and the HP 64700. The data communications parameters need to
be set correctly for both devices. Also, if you are in a remote location from the
host, line noise may cause the failure.
Run failed during CMB execute (Async_Error 694)
Cause: System failure or target condition.
Action: Run performance verification (pv command), and check target system.
Sequence term not contiguous: <term> (Error 1225)
Cause: This error occurs when you attempt to insert a sequence term that is not
between existing terms or after the last term.
Action: Be sure that the sequence term you enter is either between existing
sequence terms or after the last sequence term.
Sequence term not defined: <term> (Error 1227)
Cause: This error occurs when you attempt to delete or specify a primary branch
expression for a sequence term number that is possible, but is not currently defined.
Action: Insert the sequence term, and respecify the primary branch expression for
that term.
430