HP MC68360 User Manual page 446

Chapter 12: Emulator Error Messages
Modified register(s) caused change in emulator mode (Status 155)
Modified register(s) caused change in emulator mode (Status 155)
Cause: You changed the value of the empepar register that affects whether the
upper address bits will be ADDR[31-28] or WEx[3-0] while the emulator was not
in the reset state. The emulator mode of operation is dependent on the value of
empepar.
Action: This is a status message. You can reset the emulator and continue
operation.
Monitor must be mapped on a 4K byte boundary (Error 146)
Cause: You tried to map the emulation foreground monitor to a base address that is
not a 4-Kbyte boundary. The emulation foreground monitor must be mapped on a
4-Kbyte boundary (address XXXXX000H).
Action: Respecify mapping of the emulation foreground monitor to ensure that it is
on a 4-Kbyte boundary.
No map terms available; maximum number already defined (Error 7212)
Cause: You tried to add more mapper terms than are available for this emulator.
For example, with the MC68360 emulator, there are only eight terms. If you had
already defined memory types for these terms, then tried to map another term, you
would see the above error message.
Action: Either combine map ranges to conserve on the number of terms or delete
mapper terms that aren't needed.
No module specified for local symbol (Error 882)
Cause: This error occurs because you tried to specify a local symbol name without
specifying the module name where the symbol is located.
Action: Enter the module name where the local symbol is located, followed by a
colon, and then the local symbol name.
426