Table of Contents
Advertisement
Chapter 11: Emulator/Analyzer Interface Commands
RANGE
RANGE
The RANGE parameter allows you to specify a condition for the trace
measurement, made up of one or more values.
The range option can be used for state qualifier labels. Range can only be used
once in a trace measurement.
Refer to the "Qualifying Trigger and Store Conditions" section in Chapter 7,
"Using the Emulation-Bus Analyzer" for a list of the predefined values that can be
assigned to the status state qualifiers.
Expression types are "address" when none is chosen.
The parameters are as follows:
address
The value following this softkey is searched for on the lines that monitor the
emulation processor's address bus.
data
The value following this softkey is searched for on the lines that monitor the
emulation processor's data bus.
--EXPR--
An expression is a combination of numeric values, symbols, operators, and
parentheses, specifying an address, data, status, or executed address value. See the
EXPR syntax diagram for details.
<external_label>
This represents a defined external analyzer label.
364
Advertisement
Table of Contents
