Table of Contents
Advertisement
Installation
This chapter shows you how to install emulation and analysis interface software.
Installation of emulation and analysis hardware, and performance verification
procedures, are shown in Hewlett-Packard's MC68360 Emulator/Analyzer
Installation/Service/Terminal Interface User's Guide. These installation tasks are
described in the following sections:
•
•
•
Minimum HP 9000 Hardware and System Requirements
The following is a set of minimum hardware and system recommendations for
operation of the Graphical User Interface on HP 9000 Series 300/400 and Series
700 workstations.
HP-UX For Series 9000/300 and Series 9000/400 workstations, the minimum
supported version of the operating system is 7.03 or later. For Series 9000/700
workstations, the minimum supported version of the operating system is version
8.01.
Motif/OSF For Series 9000/700 workstations, you must also have the Motif 1.1
dynamic link libraries installed. They are installed by default, so you do not have to
install them specifically for this product, but you should consult your HP-UX
documentation for confirmation and more information.
Hardware and Memory Any workstation used with the Graphical User
Interface should have a minimum of 16 megabytes of memory. Series 300
workstations should have a minimum performance equivalent to that of a
HP 9000/350. A color display is also highly recommended.
From here, you should proceed to the section titled "Installation for HP 9000
Hosted Systems" for instructions on how to install, verify, and start the Graphical
User Interface on HP 9000 systems.
454
Installing HP 9000 software.
Installing Sun SPARCsystem software.
Verifying the installation.
Advertisement
Table of Contents
