HP MC68360 User Manual page 472

Part 5
Installation and Service Guide
In This Part
Part 5 of this book shows you how to:
•
•
The Hewlett-Packard M68360 Emulator/Analyzer Installation/Service/Terminal
Interface User's Guide shows you how to:
•
•
Refer to the Hewlett-Packard For a thorough analysis of possible problems and
solutions, refer to the Hewlett-Packard M68360 Emulator/Analyzer
Installation/Service/Terminal Interface User's Guide.
452
Chapter 14, "Installation," shows ou how to install emulation and analysis
interface software that supports the Graphical User Interface and the Softkey
Interface. Included are instructions for installing this software on HP 9000
systems and Sun SPARCsystems.
Chapter 15, "Installing/Updating Emulator Firmware," shows you how to
update your emulator/analyzer firmware with the progflash command, and
display current firmware version information.
Connect the emulator into an MC68360 target system and overcome the
differences between the specifications and characteristics of the target
microprocessor and those of the emulator.
Install the emulator hardware into the card cage. It also shows how to install
the demo board power cable, SRAM modules, rivets and covers, and the
emulator probe cable. Then it shows you how to connect the probe to the demo
board, and verify performance of the hardware