Table of Contents
Advertisement
Chapter 3: Starting and Exiting HP 64700 Interfaces
Starting the Emulator/Analyzer Interface
Examples
To start the emulator/analyzer interface for the 68360 emulator:
$ emul700 em68360 <RETURN>
The "em68360" in the command above is the logical emulator name given in the
HP 64700 emulator device table file (/usr/hp64000/etc/64700tab.net).
# Blank
lines
and
# The information in each line must be in the specified order, with
# for
each
HP series 64700 emulator.
#
#--------+------------+-----------+-------------------------------------------
# Channel|
Logical
#
Type
|
Name
#--------+------------+-----------+-------------------------------------------
#
lan:
em68360
serial:
em68360
If you're currently running the X Window System, the Graphical User Interface
starts; otherwise, the Softkey Interface starts.
The status message shows that the default configuration file has been loaded. If the
command is not successful, you will be given an error message and returned to the
UNIX prompt. Error messages are described in Chapter 12, "Emulator Error
Messages".
To start the interface using the default
configuration
• Use the emul700 -d <emul_name> command.
In the emul700 -d <emul_name> command, the -d option says to use the default
configuration. The -d option is ignored if the interface is already running in
another window or on another terminal.
42
the
rest of each line after a '#' character are ignored.
Use blanks or tabs to separate fields.
| Processor | Remainder of Information for the Channel
|
Type
| (IP address for LAN connections)
m68360
21.17.9.143
m68360
myhost /dev/emcom23 OFF 9600 NONE XON 2 8
one
line
Advertisement
Table of Contents
