HP MC68360 User Manual page 441

Chapter 12: Emulator Error Messages
Invalid expression: <expression> (Error 307)
Invalid expression: <expression> (Error 307)
Cause: You have entered an expression with incorrect syntax; therefore, it cannot
be evaluated. <expression> is the bad expression.
Action: Use online help. Reenter the expression, following the syntax rules for that
type of expression. Refer to Chapter 11, "Emulator/Analyzer Interface
Commands", to determine the expression type and the correct syntax for that type.
Invalid map address range: <address range> (Error 723)
Cause: You specified an invalid address range. For example, you may have
specified digits that don't correspond to the base specified, or you forgot to precede
a hexadecimal letter digit with a number, or the upper boundary of the range you
specified is less than the lower boundary.
Action: Reenter your command and the address specification. See the
<ADDRESS> and the <EXPRESSION> syntax pages in this manual for
information on address specifications. Also, make sure that the upper boundary
specification is greater than the lower boundary specification (the lower boundary
must always precede the upper boundary on the command line).
Invalid memory map attribute: <attribute> (Error 731)
Cause: The only valid memory map attributes for the MC68360 emulator are
Processor DSACKs, Target DSACKs, 32 Bit Emulation DSACKs, 16 Bit
Emulation DSACKs, and 8 Bit Emulation DSACKs.
Action: Reenter your command, using only valid memory map attributes.
Invalid memory map type: <type> (Error 730)
Cause: You specified a memory type while mapping that is not one of the
supported types: Emul RAM, Emul ROM, Target RAM, Target ROM,
Guarded.
Action: Reenter your command, specifying only one of the five supported types,
listed above.
421