Specify - HP MC68360 User Manual

Chapter 11: Emulator/Analyzer Interface Commands

specify

specify
This command prepares a run or trace command for execution, and is used with
the cmb_execute command.
When you precede a run or trace command with specify, the system does not
execute your command immediately. Instead, it waits until until an EXECUTE
signal is received from the Coordinated Measurement Bus or until you enter a
cmb_execute command.
If the processor is reset and no address is specified, a cmb_execute command will
run the processor from the "reset" condition.
Note that the run specification is active until you enter specify run disable. The
trace specification is active until you enter another trace command without the
specify prefix.
The emulator will run from the current program counter address if no address is
specified in the command.
376