Table of Contents
Advertisement
Chapter 2: Plugging into a Target System
Plugging into the Motorola QUADS Target System
3 Turn ON power. First turn on the emulator power. Then turn target system power
ON.
4 You will need to select three configuration items for the emulator. With the
Graphical User Interface on screen, choose Modify→Emulator Config... In the
Emulator Configuration dialog box, select Emulator Pod Settings. In the Pod
Settings dialog box, select the following:
•
•
•
5 Choose Execution→Run→from Reset. Verify that the Quads board boots up
and runs normally.
36
"Yes" for Buffer AS, DS and R/W.
"Off" for Clock O1 Drive to Target.
"8 bits" for Memory Size for Chip Select.
Advertisement
Table of Contents
