Table of Contents
Advertisement
The parameters are as follows:
disable
This option turns off the specify condition of the run process.
from
--EXPR--
This is used with the specify run from command. An expression is a combination
of numeric values, symbols, operators, and parentheses, specifying a memory
address. See the EXPR syntax diagram.
FCODE
The function code used to define the address space being referenced. See the
syntax diagram for FCODE to see a list of the function codes available and for an
explanation of those codes.
This is used with the specify run from command, and represents the address from
transfer_address
which the program will begin running.
run
This option specifies that the emulator will run from either an expression or from
the transfer address when a CMB EXECUTE signal is received.
TRACE
This option specifies that a trace measurement will be taken when a CMB
EXECUTE signal is received.
until
Specifies an address where program execution is to stop. The emulator will set a
software breakpoint at this address and stop execution of your program when it
reaches this address and enter the monitor.
Examples
specify run from START <RETURN>
specify trace after address 1234H <RETURN>
See Also
The cmb_execute command.
Chapter 11: Emulator/Analyzer Interface Commands
specify
377
Advertisement
Table of Contents
